Photo Electric Control Unit

Thermal Type and Electronic

Photo Electric Control Unit (PECU) is an electronic switch which is triggered at a specific light level. Based on thermal, electronic or microprocessor technology, photocells operate in a number of ways depending of the level of accuracy required.Dusk to dawn sensing – generally inaccurate light detection where the lamp switches ‘ON’ as night falls and switches ‘OFF’ shortly after sunrise.Light level detection – more accurate light detection where the photocell switches at pre-set light levels both at sunset and sunrise, typically 70/35, 55/28, 35/18 or 20/20 lux. Negative switching sets the lamp to ‘OFF’ at a lower level than ‘ON’, with positive switching acting in reverse.

TECHNICAL DATA

Full Product Specifications

Related Products

Shackle Insulator

An insulator that is used in distribution networks that works with low voltage is known as a shackle insulator. This insulator is also known as a spool insulator. These insulators can be worked in two positions like horizontal otherwise vertical.

Our products have been used in the telecom and electrical industry since our inception in 1997. These products are still in operation since their installation, which reflects the quality and robustness of these products.We have local facility for metal stamping, shearing, punching, drilling, welding and assembly. Product coating used is hot dip galvanized that comply to BS EN 1461.For Telecommunication we have Eye bolt, clamp pole iron, clamp terminating , clamp pole concrete, clamp pole headring pole iron and pole concrete, thimble open small, stay rod set, stay plate, Hook clamp IB no 1 & no 2, Integral Bearer Clamp no 1 & no 2 and bridle ring

Low voltage metal oxide surge arresters with a silicone housing NNO and MOSPO are designed for installation in low voltage power lines or junction boxes with voltages up to 1 kV.They serve as the initial level of protection against surges and other transients. The varistors of low voltage surge arresters NNO and MOSIPO are directly molded by silicone rubber, providing them with a high level of ingress protection rated at IP 67.

MODEL : IPCH-01

Insulating Piercing Connector Holder, IPCH-01 made from Aluminum Alloy high grade Tool was tested according to NFC 033-020:2013 and can with stand torque up to 40kN.

Weight : 450 g.
Minimum clamping jaw: 40 mm
Maximum clamping opening: 70 mm

Photo Electric Control Unit

Thermal Type and Electronic

TECHNICAL DATA

Full Product Specifications

Related Products

Shackle Insulator

Shackle Insulator

Pole Accessories for Telecomunication and Electrical Distribution

LV Arrester

Insulated Piercing Connector (IPC) Holder

MODEL : IPCH-01